Services


Services
Basic Steps in Rubber Product Manufacturing
When talking about the manufacturing of the rubber products, there are multiple manufacturing process that do exist. Each of the manufacturing process do have a particular benefit that will make it the ideal choice for manufacturing the certain types of the rubber products. To learn more about  rubber,  click more info. Determining and knowing the manufacturing process will aid us to understand the cost of the implications and the trade-offs. Some of the common rubber product manufacturing process are the extrusion, latex dipping, and the molding.
 
In extrusion, it begins with the unvulcanized compound that is being fed right to the extruder. Once that is is inside the extruder, the it will the be carried forward to a dye, which is considered to be a specialized manufacturing tool that is being used to be able to shape the rubber. Once that the compound will reach the dye, then its pressure from the process will then forces it right through the opening of the extruder. The extrusion manufacturing may also be impacted as well. The extrusion has advantages of being able to produce products that are of high volumes at the very lower amount of production.  Some of the very common rubber products from the extrusion is the tubing, gaskets, cords, and profiles.

Next, the latex dipping usually occur when the thin walled mold are being immerse right to the latex compound and then they are being slowly withdrawn. The total thickness can actually be increase through simple re-dipping of the product right into the latex compound.Click this website to learn more about  rubber. After dipping, ti will then fi finalized by vulcanization. The advantage of this process is that being able to dip latex the products with such thin wall and to be able to create a more complex shapes than that of the extrusion. Example of these are the balloons, gloves, grips, and the tubing.

Lastly, molding is comprise of the three process which include the compression molding , transfer molding and the injection molding. The advantage of this method is that it is suitable for the rubber compounds with those large surface areas and also the ability to be able to be used for ht rubber compounds with increase viscosity and low flow properties. But the process can be time consuming with only few production rate. Some of the very common products that is made from the molding process are the electrical insulators, the o-rings, and the silicone wristband.Learn more from https://www.encyclopedia.com/science-and-technology/chemistry/organic-chemistry/rubber.


This site was built using